tag:blogger.com,1999:blog-9121337832192251782.post6607743865045963412..comments2024-03-23T20:35:39.343+09:00Comments on The Chattering Horde: How to Paint Rat OgresOddjobhttp://www.blogger.com/profile/05382544182623094584noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-9121337832192251782.post-91776476433410357352010-10-20T16:05:53.158+09:002010-10-20T16:05:53.158+09:00Hi there. I seem to remember that when you turn th...Hi there. I seem to remember that when you turn these bases over there are small round holes that are filled. on the feet of the ROgre was a corresponding pin. I used a needle nosed file to drill out the plastic hole from the underside and then glued the foot with the pin into place in the hole that had opened up. If you do this carefully mark where you want the second hole to be by playing around with the Rogre so you don't drill out a hole in the wrong place.<br />BIG hassle! <br />Another option is to NOT mess around with these holes and instead file flat the feet of the ROgre so you have plenty of contact surface and just use regular plastic glue. I haven't done this, but unless you are planning to convert the ROgre to a Bonebreaker and have another model on top it should be fine.<br />Can't advise on the pointy-eared Elven princeling I'm afraid as I swapped my IOB elves for more Skaven!<br />Does that help? I may have forgotten how I did it...(too much warpstone...)Oddjobhttps://www.blogger.com/profile/05382544182623094584noreply@blogger.comtag:blogger.com,1999:blog-9121337832192251782.post-80325548550176769152010-10-19T12:49:38.260+09:002010-10-19T12:49:38.260+09:00Well I'm not sure if they changed it... as I d...Well I'm not sure if they changed it... as I don't have the newest Skaven, but the Skaven bonhommes usually have a piece that fits into the slot of the the base and apply glue... If not, just glue them to the base!Chrissie (darkprincess1980@hotmail.com)http://fortheloveofcrafts.wordpress.com/category/warhammer/noreply@blogger.comtag:blogger.com,1999:blog-9121337832192251782.post-51175709799637239282010-10-18T07:05:22.302+09:002010-10-18T07:05:22.302+09:00I have just bought the Blood Island starter set th...I have just bought the Blood Island starter set that includes Skaven Rat Ogres and Griffin that a High Elf Rides. My Problem is very simple, i dont know how to attach these models to the base. It is frustrating as i don't wish to break either the base or the statue. Some help would be good. <br />Yodastone79@hotmail.co.uk.Anonymousnoreply@blogger.com